PivotMaker en

The nozzles are interchangeable with different diameters to obtain different print resolutions.
Diameters availables: 0.40 - 0.60 -0.80 - 1 - 1.2 mm

Steel reinforced nozzles with diameters from 0.40 - 0.80 - 1.2 mm are also available in the market for printing abrasive materials.

Nozzle replacement takes place quickly and easily with a 7 mm wrench.

The two extruders are mainly used for printing with water-soluble support material (PVA) or for printing with two different materials/ colors.

PivotMaker has a Z-axis layer resolution of 100 microns with a dimensional accuracy of the X, Y ± 0.3 mm axes.

The printer uses for the XY axes the cartesian movement with a static support mechanism composed of cemented linear bars 16 mm INA and for the dynamic support of self-lubricated linear bars 2x10 mm.

The Z axis composed of cemented linear bars 16 mm INA and trapezoidal bars IGUS.

The movement is generated by NEMA 23 motors - 1/32 steps.

PivotMaker achieves a travel speed of 200 mm / s.

PivotMaker has an LCD control panel that allows to manage, control and modify all printing parameters, even during printing.

The parameters concern the extrusion temperature, the print bed temperature, the ventilation, the flow, the printing speed and the filament change.

PivotMaker allows the users to choose to print via USB port with the help of the computer or independently via SD card.

It is also possible to remotely control the printer and its parameters through a specific IP address and application installed on the supplied tablet.

PivotMaker have the function for the automatic change filament to simplify the installation and change of the filament.

Everytime that you want to change the filament there is a command on the control panel to activating the filament automatic filament change; the printer extrudes the filament, wait than the user installs the new spool filament, load it and start or resume printing.

This function is available also during the printing.

The printer pauses and resumes printing from the exact point where it was left.

Build plate: Heating plate and tempered glass 5 mm

Structure: Powder coated steel - lexan coating 5 mm

Frame: 45x45 aluminum profiles

XY axes: XY static support: Linear cemented shaft INA
XY dynamic support: self-lubrificated linear shaft

Z-axis : N° 4 Linear cemented shaft INA, n°4 trapezoidal shaft IGUS

Motors: NEMA 23 stepper motors. 1/32 step

Printing speed: 10 – 80 mm/s

Transfer speed: 10- 200 mm/s

PivotMaker

PIVOTMAKER

Designed for those who think big

Build Area 85x85x85 cm

Dual extruders and nozzle interchangeable

Layer resolution 100 micron

Printing temperature

Control panel

Easy handling

Filament detection

Automatic bed calibration

Wire change system

Printing materials

Technical specification

CONTATTI

COMMUNITY

UTILITY

NEWSLETTER